Home | Bearing Blog | Facebook | Instagram Welcome to Enderui bearing website

Stock list

Rolling bearing Assembly process concepts and terminology

Author:   Date:2013/9/23

  1. the plane perpendicular to the contact angle to the bearing axis (radial plane) with a Heli to the rolling bearing rings or washers transmission line (known as wire) the angle between them.
  2. ball set (OD) within one ball bearing (outside) the diameter of the cylinder.
  3. the roller set (external) diameter radial contact roller bearings columns roller (outside) the diameter of the cylinder.
  4. the two theories of the nominal width of the bearing ring face (back of the washer) distance. To qualify the radial width (height of thrust bearing).
  5. the actual width of the bearing axis of radial lines and qualify the actual faces of the rings of the bearing width distance between two tangent plane intersections. Qualified with the inner ring and outer ring side face the bearing width.
  6. the actual deviation of width of bearing the actual width of the bearing with the difference between the nominal width.
  7. the complete sets of bearing inner ring radial runout Kia inner ring on a different corner locations, hole with relative to the outer ring between the fixed points of difference between the maximum and minimum radial distance. Angular position or being in the vicinity of the above-mentioned points on both sides of the rolling back of the inner and outer ring raceway and inner ring flanges (tapered roller bearing) face contacts within components of the bearing is in the normal position.
  8. the complete sets of bearing outer ring radial runout of Kea outer ring at a different corner locations, outside diameter surface with a fixed relative to the inner ring of the difference between the maximum and minimum radial distance. Angular position at above or in the vicinity of rolling elements on both sides should be on the back of inner and outer ring raceway and inner ring flanges (tapered roller bearing) face contacts within components of the bearing is in the normal position.
  9. the complete sets of bearing inner ring raceway beating Sia corner of the inner ring at different positions, from the inner ring axis radial distance is equal to half of the inner ring raceway contact diameter, inner ring ends base with a fixed relative to the outer ring difference between maximum and minimum axial distance between points. Internal and external Raceway should contact with all roll.
  10. the complete sets of bearing outer ring side face Raceway beating Sea corner of the outer ring in a different location, away from the outer ring axis radial distance is equal to half of the outer ring raceway contact diameter, outer ring base face with a fixed relative to the inner ring difference between maximum and minimum axial distance between points. Internal and external Raceway should contact with all roll.
  11. end face inner hole to beat Sd from the inner ring axis of radial distance is equal to its Raceway contact diameter half, perpendicular to the ring plane and axis lines ring base facing the difference between maximum and minimum axial distance between.

Relative News

Relative Products

There is no message.

Online Messages

Company:
Email:
Message:
ValidateCode:
click refresh <--Not see, click refresh

HOME Bearing Brand News Company Contact Payment Service Delivery Guide

LIAOCHENG ENDERUI BEARING Co., Ltd.  TEL:+86 13561215822  FAX:+86-635-8429396  LinksQQ:
Technical Support:zcwz.com